Air Pneumatic heat pressing instructions (Powder System)

Created by service Department, Modified on Thu, 9 Feb, 2023 at 7:56 AM by service Department

A picture containing text, clipart
Description automatically generated

Pneumatic/air heat press is necessary for this application. A high amount of pressure is required to apply the transfer to the substrate or garment. The high amount of pressure ensures that the no-powder DTF transfers into the weave of the textured substrate. Dual silicone pads are recommended in some applications. CobraFlex Printers & are dealers that recommend that you test every product before going into production as each item may have different characteristics. These settings below are a point of reference for application only.

Product	Temp	Air-Pneumatic Heat Press	Pre-Press	Press-Transfer	Post-Press
100% Cotton	320 Degrees	140-150 PSI	Warm Platten	5 Seconds	1-2 Seconds
50/50	320 Degrees	140-150 PSI	Warm Platten	5 Seconds	1-2 Seconds
100% Polyester	320 Degrees	140-150 PSI	Warm Platten	3 Seconds	1-2 Seconds